Single Position Oxyfuel Bevel Unit
FOR X-AXIS BEVEL CUTS
Manually adjusted Single Position Triple Torch Oxyfuel Bevel Unit for straight line bevels with manual ignition and gas adjustment. Bevels can be cut in the X axis only. Cutting a “V”, “Y”, or “K” cross section in one pass, the manually adjusted Triple Torch Oxyfuel Unit is designed to make a bevel cut in the longitudinal (X) axis. Height sensing is achieved by an electromechanical device that rides on the plate.
- Provides plate squaring and weld preparation edges
- Bevel angles up to 45°
- Torches may be adjusted from .375” (9.5 mm) to several inches apart using retracktable dove-tail horizontal slides providing for a wide range of bevel angles that can be cut on a variety of material thicknesses
- Height control is locked out when the electromechanical devise runs off the plate, maintaining proper height through the end of the cut.
- Often used in combination with a Three Position Oxyfuel Bevel Unit to accurately establish plate width.